兩支架混合四腔的注塑模具設計
打開文本圖片集
Injection mold design of two-support combined four-cavity
SONG Jinya
（Shanghai Technical Institute of Electronics and Information， Shanghai 2O1411， China）
Abstract： Based on the analysis of the structural characteristics of two supports with large structural differences，the preliminary design of four-cavity mold was completed by mixing them in the same mold according to the actual needs. The simulation of flow channel balance was carried out by using Moldflow. The size of branch runner and gate was optimized. The cooling water channel was circulating. The analysis results of °cooling+filling+holding+ warping’ show that the temperature difference between the inlet and outlet of the cooling medium does not exceed 0.33K ，and the filling effect is relatively balanced.The maximum total warping deformation of the two supports is 0.1385mm and 0.1478mm ，respectively， which meets the requirements. Three sets of sliders and two sets of lifters were used to realize side core parting and stripping. Multiple inserts in the cavity and core could reduce the cost and facilitate mold repair. Finally，a set of combined four-cavity two-plate injection mold which can be used in actual production was obtained. It can provide some reference for the injection mold design of combined multi-cavity and unbalanced runner with different models.
Key words： combined four-cavity； injection mold; mold design； mold flow analysis；warpagedeformation
0 引言
注塑模具由于制作成本較高，如果前期設計過程中存在問題，輕則導致頻繁修模，重則導致整套模具報廢，會帶來較大的損失，而利用模流分析軟件Moldflow在模具設計初期進行仿真分析，可有效降低設計失誤，提升設計效果，降低成本，縮短項目周期[1-4]。（剩余7811字）