單相浸沒式液冷常用冷卻液性能比較及選型
打開文本圖片集
中圖分類號：TQ013 文獻標志碼：A 文章編號：1001-5922（2025）05-0127-04
Abstract：The performance of several commonlyused single-phase immersion coolants was compared，and the effects of coolant inletflowrate and heating power on the effect of colant-coled electronic component substrates were analyzed.The test results showed that among several commonly used single-phase immersion coolants，the electronic fluorinated fluidFC-3283had the best cooling efecton the substrate，and the mineral oil hadthe worstcoling effect.Under the conditions of 200W heating power and O.O5 m/s inlet flow rate，the maximum temperature of the cooled substrate of mineral oil was ，thestandard temperature difference was 3.8 C ，andtherelative thermal resistancecoeffcient was about 2.98，while the maximum temperatureof thecooled substrate of electronic fluorinated liquid FC -3283 was about ，the standard temperature difference was about 1.9 C ，and the relative thermal resistance coefficient was about 1.58.When the thermal power was 400W andthe inlet flow rate was 0.05m/s ，the maximum temperature of the mineral oil-cooled substrate exceeded ，and the cooling effect did not meet thecooling requirements of electronic components.The maximum temperature of the substrate coled by the electronic fluorinated fluid FC -3283 was about 62.3degreeC ，which shows good cooling performance and meets the cooling requirements of electronic components.
KeyWords：singlephase immersioncooling；liquid cooledcoolant；cooling performance；cooling effctof electronic components
隨著現代信息技術的高速發展，對數據中心規 模也有了更高的要求，電子元件熱功耗也隨之增加，
服務器的冷卻需求也越來越高。（剩余5117字）