預制梁鋼筋閃光對焊的質量控制

打開文本圖片集

摘要： 鋼筋焊接采用閃光對焊，焊接接頭存在一次性抽檢率合格率較低，導致施工中出現返工，既延誤了工期、又浪費了人力物力，同時留下了質量隱患。文中從鋼筋閃光對焊接頭質量檢驗及驗收幾個方面展開論述。

關鍵詞： 鋼筋閃光對焊、連續閃光焊、原因分析及要因確認、制定對策

中圖分類號： TG 47

Quality control of flash butt welding of precast beam reinforcement

XU Long

（Jingzhou Huacheng Construction Engineering Quality Inspection Co.， Ltd.，Jingzhou，434001 Hubei，china）

Abstract： Flash butt welding is used in the welding of steel bars， and the one-time spot inspection rate of the welded joints is low，Lead to rework in the construction， not only delayed the construction period， but also a waste of human and material resources，And left a quality hazard.In this paper， the quality inspection and acceptance of flash butt welding of Steel Bar are discussed.

Key words：  Steel Bar flash butt welding， continuous flash welding， cause analysis and cause confirmation， make countermeasures

0 前言

閃光對焊廣泛用于碳鋼、合金鋼、有色金屬的管、棒、板、型材之間的對焊或異類金屬之間的對焊［1-6］。（剩余4010字）