含孔洞復合材料結構的拉伸性能仿真

打開文本圖片集

摘 要 本文針對含中心孔洞和含多孔復合材料結構模型，利用Fibersim進行鋪層設計并檢驗鋪層角度是否偏差，對于含中心孔洞復合材料結構采用分區域鋪覆的設計方法進行探究，發現可以達到在制造中節省材料成本的作用。將兩種結構進行仿真失效計算同時與不開孔狀態的復合材料結構進行比較，得出失效比值。

關鍵詞 Fibersim；有限元仿真；復合材料；鋪層設計

Simulation of Tensile Properties of Composite

Structures Containing Holes

CHEN Yinghan， LIU Jiaqiu， YU Baifeng， LIU Jia， HAO Chenwei

（Harbin FRP Institute Co.，Ltd.， Harbin 150028）

ABSTRACT In this paper， we use Fibersim to design the lay-up for center hole and porous composite structure model， check whether the layup angle is deviated or not， and explore the design method of lay-up by area for center pore composite structures， and find that it can achieve the role of saving the material cost in manufacturing. The two structures were subjected to simulated failure calculations while comparing them with the composite structure in the unopened state to derive the failure ratio.

KEYWORDS fibersim; finite element simulation; composite material; lay-up design

通訊作者：陳英函，碩士，助理工程師。（剩余3745字）