電線電纜成束燃燒試驗試樣長度選擇的研究
打開文本圖片集
摘要：電線電纜成束燃燒試驗?zāi)軌蚍磻?yīng)電線電纜的阻燃性能，在日常的監(jiān)督抽樣過程中抽樣人員往往很難確定燃燒試驗所需的樣品長度，文章通過分析研究找到快速確定試樣長度的合理方法，以便在日常抽檢工作中快速確定試樣長度。
關(guān)鍵詞：成束燃燒；電線電纜；分析研究；長度
Study on the Selection of Sample Length for Bundled Combustion Test of Wires and Cables
FENG Xiaohua
（ Nanping Institute for Product Quality Inspection， Nanping 353000， Fujian， China ）
Abstract： It is difficult to determine the required length of the sample in the routine supervisory sampling process because the bunched combustion test of wires and cables can reflect their flame retardant performance. However， it is often challenging for samplers to determine the required sample length for the combustion test during routine supervisory sampling. This paper presents a reasonable method ，derived through analysis and research， for rapidly determining the sample length， facilitating efficient sample length determination in routine sampling inspections.
Key Words： Burning combustion; Wires and cables; Analytical studies; Length
0引言
電線電纜成束燃燒試驗[1]最新標準刪除了原附錄C中試樣根數(shù)的簡易計算方法，僅在GB/T 18380.33-2022 《電纜和光纜在火焰條件下的燃燒試驗 第33部分：垂直安裝的成束電線電纜火焰垂直蔓延試驗A類》中得以保留，因此在運用GB/T 18380.34-2022、GB/T 18380.35-2022、GB/T 18380.36-2022等標準時，不能直接使用舊標準規(guī)定的簡易計算方法。（剩余4532字）